Ordered copper integrated mesoporous silicate catalysts (CuMSC) have been synthesized by the utilization of the amphiphilic tri-block copolymer pluronic F127 as a structure directing agent (SDA) under acidic aqueous conditions. The mesophase of the materials was investigated using small-angle powder X-ray diffraction and transmission electron microscopic (TEM) image analysis. N2 adsorption-desorption studies show that the BET surface area of CuMSC (214-407 m(2) g(-1)) is lower than that of pure silica (611 m(2) g(-1)) and has smaller average pore dimensions (4.0-5.0 nm), both prepared following the same synthetic route. The reduction of pore size and surface area points to incorporation of copper within the silicate network. FEG-SEM results suggest that the materials have a plate-like morphology and are composed of very tiny nanoparticles. EDS surface chemical analysis was utilized for the detection of the distribution of Si, O and Cu in the matrix. The FT IR spectral study suggests the complete removal of the surfactants from the calcined materials and the presence of Si-O-Cu bonds for high nominal contents. X-ray photoelectron spectroscopy (XPS) and UV-vis reflectance spectra show the oxidation state of copper and coordination mode, respectively. These mesoporous materials display a good catalytic activity in the oxidation of cyclohexane to cyclohexanone and cyclohexanol in the presence of the green oxidant hydrogen peroxide. The maximum yield (cyclohexanone and cyclohexanol) was ca. 29% and the TON (turnover number) was 276 under optimal reaction conditions. The good catalytic activity could be attributed to the large surface area and the presence of a high number of active sites located at the surface of the material, as well as to its stability. The catalysts showed negligible loss of activity after five cycles.