Solid thin films have been deposited on carbon steel substrates in a chemical vapor deposition (CVD) reactor where natural gas, mostly methane (CH4), was used as a precursor gas. The effect of gas flow rate on the thin film deposition rate has been investigated experimentally. The effect of gap between activation heater and substrate on the deposition rate has also been observed. To do so, a hot filament thermal chemical vapor deposition unit is used. The flow rate of natural gas varies from 0.5 to 2 l/min at normal temperature and pressure (NTP) and the gap between activation heater and substrate varies from 4 to 6.5 mm. Results show that the deposition rate on carbon steel increases with the increase of gas flow rate. It is also seen that deposition rate increases with the decrease of gap between activation heater and substrate within the observed range. These results are analyzed by dimensional analysis to correlate the deposition rate with gas flow rate, surface roughness and film thickness. In addition, friction coefficient and wear rate of carbon steel sliding against SS 304 under different normal loads are also investigated before and after deposition. The obtained results reveal that in general, the values of friction coefficient and wear rate are lower after deposition than that of before deposition.