Two potential pathways for Li+ diffusion occur within graphitic carbon with typically in-plane diffusion dominating (∼10-7 cm2 s-1) over diffusion along the crystallite grain boundaries (∼10-11 cm2 s-1). Reducing the flake thickness of microcrystalline graphite powders via electrochemical exfoliation offers a method to overcome the latter, sluggish grain boundary Li+ diffusion, thereby increasing the overall rate capability of the graphite negative electrode in a the Li-ion battery. Six micron particulate graphite was electrochemically exfoliated to give flakes of which ∼90% had a thickness of < 10 graphene layers. This exfoliated material was then prepared as an ink and allowed to dry prior to forming a battery electrode. Analysis of the electrode and dried exfoliated powder using powder x-ray diffraction, scanning electron microscopy and Brunauer-Emmett-Teller isotherm analysis show that the material has, apart from a significant reduction of the rhombohedral fraction from 41 to 14%, near-identical properties to that of original starting graphite powder. Thus, once the exfoliated powder has been dried from the exfoliation process, as anticipated, major restacking of the multi-layer graphene flakes had occurred. Likewise there was no significant improvement in using the exfoliated material at high rates of delithiation and lower specific capacity, when tested within a half cell vs. lithium metal. In situ Raman analysis showed that the exfoliated material displayed similar spectral features to the pristine sample during lithiation, as did multi point measurements on differently disordered areas shown from the varying ID/IG-band intensity ratios, indicating that local surface disorder does not influence the course of lithium insertion. The re-aggregation of graphenic material is widely recognised, but seldom evaluated. This work shows the importance of keeping graphenic material dispersed at all stages of production.