The determination of cohesive laws for describing large scale failure process zones is discussed. Firstly, a general approach for determination of cohesive laws, by the measurement of the J integral and end-opening of the cohesive zone of double cantilever beam specimens loaded with pure bending moments, is described. Next, two case stories are reviewed: failure of adhesive joints and splitting of a unidirectional carbon fibre/epoxy composite. For the adhesive joints, measured failure strengths of bonded panels having a central notch were found to in very good agreement with predictions from cohesive law parameters determined on test specimens. For the problem of splitting of unidirectional composites, micromechanisms were observed in situ during cracking. A cohesive law shape, predicted by a micromechanics model, was found to agree well with macroscopic cohesive law determined by the J integral approach. The cohesive law was used for predicting effect of specimen shape on strength; predictions were confirmed by experiments. Finally, some ideas regarding determination of mixed mode cohesive laws are discussed.