A novel low-clay translucent whiteware body, using mostly non-plastic prefired materials and only a small amount of clay, was fabricated by slip casting and the effect of slip's solid content and sintering temperature on the mechanical behaviour was investigated. The degree of densification in the sintered specimens was determined by measuring the bulk density. The mechanical behaviour was determined by measuring the flexural strength and fracture toughness. Young's modulus and hardness were also measured. X-ray diffraction (XRD) and scanning electron microscopy (SEM) studies were carried out to analyse the microstructure.The flexural strength and fracture toughness increase with both increasing the slip's solid content and the sintering temperature up to a certain level, but further increase in solid content and sintering temperature had an adverse effect on the properties. The maximum flexural strength (∼135MPa) and fracture toughness (∼1.85MPam1/2) values were attained with specimens produced from a slip having 45vol.% solid content at a sintering temperature of 1350°C. It was found that the amount and distribution of closed pores, their size and possible link with each other control the flexural strength and fracture toughness of the low-clay translucent whiteware.